** Currently awaiting a restock expected by February **

Burton - Winder Speed Zone Snowboard Boot Laces Upper & Lower

Includes re-lacing tool too!

Triangle scrapers offer more sharp edges to use.

Our 6 inch long, clear, ultra thick snowboard wax scraper is made from 1/4" thick high grade acrylic producing a super sharp edge and the extra thick material is heavy duty and has zero flex.  Acrylic is a better material than simple plastic because of the ability to get a sharp edge.  If the edge gets built up with wax or starts to feel dull run it across a steel file or some sand paper to sharpen it back up.  Notched corner allows for easy cleaning of wax off your steel edges. All you need to get the job done.

Size: 3" x 6" x 1/4" thick

Our 12 inch long snowboard wax scraper allows you to cover a lot of ground with each pass.  Made from 1/8" thick high grade acrylic producing a super sharp edge.  Acrylic is a better material than simple plastic because of the ability to get a sharp edge.  If the edge gets built up with wax or starts to feel dull run it across a steel file or some sand paper to sharpen it back up.  Notched corner allows for easy cleaning of wax off your steel edges. All you need to get the job done.

Instructions:

1. Select correct temperature specific wax by checking mountain conditions/snow report...(actual snow temperature, not air).

2. Press wax on the iron and distribute small drips of wax over the entire base. DO NOT ALLOW IRON TO SMOKE!

3. With iron in hand, slowly pull the iron over the wax drips smoothing them into a sheet of wax that covers the entire base tip to tail.

4. Let the wax cool 10-15 minutes, then scrape with a sharp plastic scraper. DO NOT USE a steel scraper.

5. Use a wax brush or fiber pad, remove excess wax from base, brushing from tip to the tail. This allows your base to glide fast. 

THE ORIGINAL one-piece hooded base layer, developed to near perfection over the course of 12+ years of testing and abuse by Ninja Ambassadors. Experience all of the Ninja novelty benefits in your new favorite NECESSITY!

• 7-panel form-fitting hood
• 4-Way stretch Air Tech fabric
• Thumb loops at cuff
• Full length front chest zip
• 350 degree waist zip for easy #2 access

This is hands down our shop's favorite base layer, don't hit the mountain without it. Available in men's and women's!

• A Jbar Four-Pack

• Get the best fit possible. Jbars reduce heel lift inside your boots when they are fully laced up.

• Compatible with: All Burton snowboard boots